Wear Resistant Material Foam Transfer Pump Expeller OEM / ODM
Foam transfer pumps
has been designed to increase the pumpability of frothy slurry. The
pump operation is similar to hydrocyclone seperation.
The basic principle of the froth pump operation is to de-aerate or
partially de-aerate the froth before it enters the pumping. Its
handling capacity of the pump is muchhigher than that of other
types of slurry pump without shaft seal and sealing water.
1. Bearing assembly: large diameter shaft with short overhang
contributes to long bearing life.
2. Liners: Easily replaceable liners are bolted, not glued to the
casing for positive maintenance.
3. Casing: Casing halves of cast or ductile iron provides high
operating pressure capabilities.
4. Impeller: Front and rear shrouds have pump out vanes that reduce
recirculation and seal contamination.
5. Throat bush: Wear is reduced and maintenance simplified by the
use of tapered.
Slurry pump parts--packing (pump seal)
The sealing method contains packing seal, centrifugal seal and
mechanical seal. The packing is usually used for packing seal and
centrifugal seal, and our product has different models .Clients are
recommended to buy two boxes of packing at one time which are
sufficient for one pump
Slurry pump spare pats-Volute liner
This is volute liner for slurry pump with excellent wear
resistance, corrosion resistance and large passage area.
Good casing design makes maintenance easily and cost much lower.
Advanced heat treat technology is used to treat high chrome alloy
and results with a compact micro-structure and a high quality
Slurry pump parts-bearing assembly
Bearing assembly uses cylindrical structure, adjusting the space
between impeller & front liner easily, being removed completely
when being repaired.