Rubber Lined slurry pump parts of Centrifugal Mining Slurry Pump
Slurry pump parts
Completely interchangeable with slurry pumps and gravel pumps
For unlisted slurry pump parts, OEM service offered---Drawings
- Metal Liner
- Rubber Liner
- Bearing Assembly
- Pump Volute;
- Cover Plate & Frame Plate
Slurry pump parts-----impeller:
The pump impeller is made of rubber or metal, and the metal liner
and rubber liner are interchangeable .The back vane can reduce the
sealing pressure ,and it can also cut down backflow to the largest
extent at the same time .On the other hand ,cast-in impeller
threads are more suitable for slurry .
Slurry pumps parts-cover plate liner & frame plate liner
The cover plate is produced using elastomer or hard metal,
such as natural rubber, high - chromium alloy, etc.
It has various sizes and styles, and the installation is very easy.
Additionally, OEM design is accepted. This product is also named as
slurry pump liner, and it is also an overflow component. It can
form a pump chamber with throat bush and frame plate liner insert.
Meanwhile, it is white iron with high-chromium alloy whose content
as much as 27%, and it shows good resistance to abrasion
High chrome alloy: A05, A07, A33, A49, etc.
Natural rubber: R08, R26, R33, R55, etc.
Other material as per requests, like stainless steel, duplex
stainless steel, Nickle alloy, Alloy 20, etc.
|Part Name||Material||Specification||HRC||Application||OEM Code|
|Liners & Impeller||Metal||AB27: 23%-30% chrome white iron||≥56||Used for higher wear condition with pH between 5 and 12||A05|
|AB15: 14%-18% chrome white iron||≥59||Used for higher wear condition||A07|
|AB29: 27%-29% chrome white iron||43||Used for lower pH condition especially for FGD. It also can be used
for low-sour condition and desulfuration installation with pH no
less than 4||A49|
|AB33: 33%-37% chrome white iron|| ||It can transport oxygenated slurry with pH not be less than 1 such
as phospor-plaster, nitric acid, vitriol, phosphate etc.||A33|
|Rubber|| || || ||R08|
| || || ||R26|
| || || ||R33|
| || || ||R55|
|Expeller & expeller ring||Metal||B27: 23%-30% chrome white iron||≥56||Used for higher wear condition with pH between 5 and 12||A05|
|Grey iron|| || ||G01|
|Stuffing Box||Metal||AB27: 23%-30% chrome white iron||≥56||Used for higher wear condition with pH between 5 and 12||A05|
|Grey iron|| || ||G01|
|Frame/Cover plate, bearing house & base||Metal||Grey iron|| || ||G01|
|Ductile iron|| || ||D21|
|Shaft||Metal||Carbon steel|| || ||E05|
|Shaft sleeve, lantern ring/resctrictor, neck ring, gland bolt||Stainless steel||4Cr13|| || ||C21|
|304 SS|| || ||C22|
|316 SS|| || ||C23|
|Joint rings & seals||Rubber||Butyl|| || ||S21|
|EPDM rubber|| || ||S01|
|Nitrile|| || ||S10|
|Hypalon|| || ||S31|
|Neoprene|| || ||S44/S42|
|Viton|| || ||S50|